Meet the next generation ofmonsters from Castle Creations!
Castle Creations Mamba MonsterX 2650KV 1:8 Brushless Set / Waterproof ***
Specifications Mamba MonsterX ESC:
NEW Sensor Connector
NEW MonsterX data logging function
NEW Telemetry function
Input voltage: MIN: 2S (7.4V) LiPo / MAX: 6S (22.2V) LiPo
Max . Continuous load: 120A (full throttle or brake with fan)
BEC: 5.5V, 6.0V, 7.5V, 8.0V (adjustable) / 8A peak - default 5.5V
Reverse: Yes - with lockout
Dimensions: length: (53mm) Width:(49mm) Height: (34mm)
Weight (without cable): 111.1 grams
Compatible with Futaba T4PX
Technical Data 2650KV Sensor Motor:
Max input voltage: 16.8 volts (4S 14.8V)
Ampere Rating***: 120 Ampere
Max. Speed: 60,000
Weight: 370 grams
Motor Diameter: 39.98mm / 41.78mm (with cooling mills)
Motor length: 68mm
Shaft diameter: 5mm
Ball bearing: Oversize ABEC-1 rear & front
Connector: 6.5mm gold contact
Values recordablewithMonsterX Data Logging:
(Link Live mode must be enabled via Castle Link USB Adapter to enable telemetry link communication.Compatible with Futaba T4PX)
Values adjustablewith Castle Link USB Adapter(optionally available under #010-0005-00 or #010-0063-00)
- Battery voltage
- Battery power
- Motor Power
- BEC Voltage
- Controller (ESC) Temperature
- Battery Ripple
- Throttle Curve
- Throttle power
- Brake curve
- Brake power
- Motor timing
- Channel inversion
- LiPo cutoff
- Drag Brake
- Save / Load controller settings
Scope of delivery:
- Mamba MonsterX 1:8 brushless controller 120A (incl. mounted cooler & on,/off switch)
-210mm long sensor cable (for sensor controlled driving pleasure)
- Castle Sensor Harness Adapter
- Castle Creations Brushless Inrunner Sensor Motor 1512 2650KV
- Receiver cable (BEC cable) incl. connector (already mounted)
The controller and motor are waterproof and can therefore be driven in all weather conditions
. Whether in snow, mud, rain, etc..
However, the controller and regulator are not suitable for driving under water!
Clean/clean the controller and motor after each use with clean water from mud/dirt/spray water etc.
and dry everything completely before you use both again.
The fan of the controller is not waterproof.
Dismantle this when driving in a damp environment!