current lead time: 4-5 weeks
energy Efficiency.
cC CapPack is useful in all brushless motor applications where it serves to provide just that little boost needed to overcome ripples in battery voltage caused by hard acceleration or long battery wires. Ripple voltage is hard on an ESC - adding the CC CapPack can help reduce the load on the controller's on-board capacitors. This CapPack uses four 560µF, 35V capacitors totaling 2240µF, which increases its ripple reduction. It can be used...
mehr anzeigen
weniger anzeigen
current lead time: 4-5 weeks
energy Efficiency.
cC CapPack is useful in all brushless motor applications where it serves to provide just that little boost needed to overcome ripples in battery voltage caused by hard acceleration or long battery wires. Ripple voltage is hard on an ESC - adding the CC CapPack can help reduce the load on the controller's on-board capacitors. This CapPack uses four 560µF, 35V capacitors totaling 2240µF, which increases its ripple reduction. It can be used with LiPo batteries up to 8 cells. If your batteries are larger than 8s (35V), you will need the 880µF, 50V CapPack.
helis.
cC CapPack is strongly recommended for all 500-class and smaller heli applications where Y-harnesses and long wires can bleed voltage and hard collective pulls can stress even the most powerful batteries.
surface Vehicles.
with their high torque requirements - going from 0 to 100% throttle is not easy for controllers or batteries - RC cars and trucks place enormous loads on brushless drive systems. Use CC CapPacks in high-performance applications (IE drag racing and high-speed runs) to help your system survive the abuse.
fixed Wing Aircraft.
larger electric power systems lead to larger electric powered aircraft, and sometimes the distance between the battery pack and the ESC grows beyond the length of the wires installed on the components. Adding wire also adds inductance, which can increase the ripple voltage in a system. CC CapPack essentially negates the ripple caused by adding up to 12 inches of length to battery cables.
note: All Castle controllers with data logging capabilities can report the ripple voltage they encounter during use. Ripple voltage spikes should always be less than 10% of the total pack voltage. The smaller the ripple voltage, the better. If an application has a ripple voltage greater than 10% under peak loads, the user should consider using higher discharge (C-rated) batteries, shorter wires, higher current connectors, better interlocking, or a smaller load.
multiple CapPacks may be used in an application. They should all be installed as close to the ESC as possible.
Technical Specs |
Size: |
Length: 1.8' (45.7mm)
Width: 0.78' (19.8mm)
Height: 0.88' (22.1mm) |
Weight: |
N/A |
Voltage Range: |
5V - 35V |
Capacitance: |
2240µF total |